On some platforms calling high()/low() to switch line states result in
costly system calls whick makes it impossible to swith two or more tty
lines simultaneously.
To help solve this timing issue we introduce a tty line state
configuration API which can be used instead of using
high()/low().
Using config_low(line) and config_high(line) one can set up a new line
state configuration for multiple lines and then use config_apply() to
finally apply the configuration. This will result in only one system
call to instruct the serial port drive to switch all the configured line
states which should help ensure that the lines are switched
simultaneously.
Example:
script = config_high(DTR); config_low(RTS); config_apply()
Add support for running Lua scripts that can manipulate the tty control
lines. Script is activated automatically on connect or manually via in
session key command.
The Lua scripting feature opens up for many posibilities in the future
such as adding expect like functionality to easily and programatically
interact with the connected device.
Make it possible to remap the prefix key (default: ctrl-t) by setting
the prefix-ctrl-key variable in the configuration file.
Allowed values are in the range a..z.
Example, to set the prefix key to ctrl-a simply do:
prefix-ctrl-key = a
Added command line options:
-O, --eol-delay to have a separate delay for end of line
-U, --upper to enable translation of lower case alpha to upper case
Added ability to set mark parity.
Added ctrl-t U key sequence to allow enable/disable lower case alpha to
upper case during a session.
Updated Man page with command line options, ctrl-t sequences and
configuration file options.
Updated README.md, with above information.
MCUs like the ESP32 can be reset if the serial port DTR line is
pulsed for a short time. You could just type CTRL-t d CTRL-t d
but that's a little awkward since you have to lift your finger
off the CTRL key to type the Ds. Now you can just type CTRL-T D.
* Added new command "D" to pulse the DTR line. I.E. Toggle its
state twice with a configurable duration between toggles.
* Added new config/command line option "--dtr-pulse-duration"
to set the duration between the DTR state toggles. The default
is 100ms.
Add support for a non interactive mode which allows other application to
pipe data to tio which then forwards the data to the connected serial
device.
Non ineractive means that tio does not react to interactive key commands
in the incoming stream. This allows users to pipe binary data directly
to the connected serial device.
Example use:
$ cat commands.txt | tio /dev/ttyUSB0
