Make it possible to remap the prefix key (default: ctrl-t) by setting
the prefix-ctrl-key variable in the configuration file.
Allowed values are in the range a..z.
Example, to set the prefix key to ctrl-a simply do:
prefix-ctrl-key = a
Clean up so that only the following error related printing functions are
used: tio_error_printf(), tio_error_printf_silent(),
tio_warning_printf().
A session mode switch is introduced for error printing so that it will
print error messages with better formatting depending on in or out of
session.
Added command line options:
-O, --eol-delay to have a separate delay for end of line
-U, --upper to enable translation of lower case alpha to upper case
Added ability to set mark parity.
Added ctrl-t U key sequence to allow enable/disable lower case alpha to
upper case during a session.
Updated Man page with command line options, ctrl-t sequences and
configuration file options.
Updated README.md, with above information.
MCUs like the ESP32 can be reset if the serial port DTR line is
pulsed for a short time. You could just type CTRL-t d CTRL-t d
but that's a little awkward since you have to lift your finger
off the CTRL key to type the Ds. Now you can just type CTRL-T D.
* Added new command "D" to pulse the DTR line. I.E. Toggle its
state twice with a configurable duration between toggles.
* Added new config/command line option "--dtr-pulse-duration"
to set the duration between the DTR state toggles. The default
is 100ms.
When enabled this option will timestamp new lines with the time elapsed
since the line before.
This is a very useful feature to identify which events takes the most
time.
