Added command line options:
-O, --eol-delay to have a separate delay for end of line
-U, --upper to enable translation of lower case alpha to upper case
Added ability to set mark parity.
Added ctrl-t U key sequence to allow enable/disable lower case alpha to
upper case during a session.
Updated Man page with command line options, ctrl-t sequences and
configuration file options.
Updated README.md, with above information.
MCUs like the ESP32 can be reset if the serial port DTR line is
pulsed for a short time. You could just type CTRL-t d CTRL-t d
but that's a little awkward since you have to lift your finger
off the CTRL key to type the Ds. Now you can just type CTRL-T D.
* Added new command "D" to pulse the DTR line. I.E. Toggle its
state twice with a configurable duration between toggles.
* Added new config/command line option "--dtr-pulse-duration"
to set the duration between the DTR state toggles. The default
is 100ms.
Add support for a non interactive mode which allows other application to
pipe data to tio which then forwards the data to the connected serial
device.
Non ineractive means that tio does not react to interactive key commands
in the incoming stream. This allows users to pipe binary data directly
to the connected serial device.
Example use:
$ cat commands.txt | tio /dev/ttyUSB0
